We started by preparing the old swing axle for the new chassis. Then the self jigging Chassis was tack welded and finally fully welded into its correct position Certain parts had to be dry fitted to ensure they would fit into the correct positions and that the mountings were correct. The whole frame went away for Powder coating. Fabrication of Dashboard and other smaller parts continued throughout the build. The polished aluminium floor and brake lines were installed. Trick electrical epi-centre box was used to keep everything safe. Note all the wiring is done in Black to keep it hidden as best as possible. Rear disc conversion will ensure it stops pretty well. Polished 70's Wolfrace Slotmags wheels are very Retro looking Aluminium body panels were fabricated and fitted using traditional panel beating methods. The 2186cc Type 1 Aircooled motor was fitted into the rear of the car, utilising an old school Scintilla Magneto for power. At present the car is awaiting painting to give it, its finished look.
Your a nosey little so and so aren't you, your even reading all the small prints that most corporate sites have written at the bottom of your screen all the time, this site is no different. It has these little words at the bottom that nobody can really read or understand. The only difference is theirs is a load of legal rubbish and mine is just humouring their words. I suppose I should really mention a few bit of legal stuff. So here we go then. Some of the images on this website may well have been stolen form other sites. For this I thank the sites for providing me the literature to use. Many thanks, you work hard so I dont have to. This saved me lots of time when publishing this site.
